Ecm Industries Llc 45-311DHUVB Dual-head Cable Tie 25 Pack

Product Description

The ECM INDUSTRIES LLC 45-311DHUVB is an 11-inch dual-head cable tie rated to 50 pounds tensile strength with UV-resistant construction, sold in bags of 25. The dual-head design lets a technician form two separate bundles from a single tie, reducing material use on runs with branching wire groups. A pre-bent tip feeds cleanly into the tie head without fumbling, and close serrations on both sides of the strap allow precise, incremental tensioning. Smooth radiused edges prevent cutting into wire insulation and reduce hand fatigue during high-volume bundling work. Finger grips on the tail end give a secure hold when cinching tight in confined spaces.

These cable ties are suited for electrical, HVAC, and low-voltage wiring applications where UV exposure is a factor, such as rooftop equipment, exterior conduit runs, and attic installations. The UV-resistant material helps maintain tie integrity in sunlight-exposed environments. Sold in a 25-count bag, this part is appropriate for service trucks, panel shops, and installation crews who bundle control wiring, line-voltage conductors, or refrigerant line insulation.

Key Features

• Dual-head design forms two independent bundles per tie
• 11-inch length with 50-pound tensile strength rating
• UV-resistant material for outdoor and sun-exposed installations
• Pre-bent tip for easy, one-hand insertion into the tie head
• Close bilateral serrations allow precise tension adjustment
• Smooth radiused edges protect wire insulation and reduce hand fatigue

Compatibility

Designed as a general-purpose dual-head cable tie for electrical, HVAC, plumbing, and low-voltage wiring bundling applications.

Installation Notes

Cable ties are installed by electricians, HVAC technicians, and low-voltage contractors as part of standard wire management practice. De-energize circuits before bundling conductors near live terminals. Avoid overtightening ties on insulated conductors, as excessive tension can damage insulation. Flush-cut excess tail length after tensioning to eliminate sharp protruding ends.