Ecm Industries Llc 20-111 Spade Terminal 22-18 Awg 600V 20 Pack

Product Description

The ECM INDUSTRIES LLC 20-111 is a 20-pack of vinyl insulated, solderless spade terminals designed for secure, tool-crimped wire terminations in low- and medium-voltage electrical applications. Each terminal accepts 22 to 18 AWG wire and fits a No. 4 to No. 6 stud. The vinyl barrel insulation provides dielectric protection rated to 600 volts maximum and a temperature rating of 167 degrees F (75 degrees C). These terminals are UL approved, making them suitable for installations where listed components are required by code. Electricians and HVAC technicians reach for these when making clean, reliable connections to equipment terminals, ground lugs, and control boards.

These spade terminals are used across residential and light commercial applications wherever a solderless, ring-free spade connection is needed. Typical use cases include control wiring on HVAC equipment, panel terminations, appliance wiring, and general low-voltage control circuits. The 22-18 AWG range covers most common thermostat, low-voltage control, and signal wire gauges encountered in the field. The 20-piece pack format suits service calls and small jobs without excess inventory.

Key Features

• Solderless crimp design — no soldering equipment required for installation
• Vinyl insulated barrel rated to 600 volts maximum
• Temperature rated to 167 degrees F (75 degrees C)
• Fits No. 4 to No. 6 stud sizes
• Accepts 22-18 AWG wire
• UL approved for use in listed assemblies
• 20-piece pack for service and small-run wiring work

Compatibility

Designed as a general-purpose spade terminal for use with 22-18 AWG wire on No. 4 to No. 6 stud terminations in residential and light commercial electrical and HVAC control wiring applications.

Installation Notes

Installation is performed by licensed electricians or HVAC technicians in accordance with NEC requirements for wire terminations and insulation ratings. De-energize and lock out the circuit before terminating or removing any wiring. Use a calibrated wire crimping tool sized for the AWG range being terminated — do not use pliers as a substitute, as an improper crimp can result in a high-resistance joint or terminal pullout. Verify stud size compatibility before seating the terminal to avoid deformation of the spade tab.