Eclipse MM10/VS/MSC Replacement O-ring 10 Inch Micromag

Product Description

The ECLIPSE MM10/VS/MSC is a replacement O-ring designed for use with 10-inch MicroMag magnetic filtration units. This sealing component maintains a leak-free connection within the filtration assembly, preventing bypass of unfiltered fluid and ensuring the magnetic filter operates at full efficiency. With an overall diameter of 10 inches and a package weight of 0.1 pounds, it is a direct-fit consumable intended for periodic maintenance during filter service intervals. Plumbers, HVAC technicians, and mechanical contractors handling hydronic or fluid systems will find this part a necessary stock item when servicing MicroMag filtration equipment.

This O-ring is used during scheduled maintenance or after-fault inspection of 10-inch MicroMag magnetic filtration assemblies. Magnetic filtration systems are commonly installed in closed-loop hydronic heating and cooling systems to capture ferrous debris and protect components such as pumps, heat exchangers, and boilers. Replacing the O-ring at each filter cleaning interval is standard practice to ensure a reliable, pressure-holding seal and prevent slow weeps that develop when a worn O-ring is reused.

Key Features

• Direct replacement O-ring for 10-inch MicroMag magnetic filtration units
• Overall diameter of 10 inches for precise fitment within the filter housing
• Lightweight consumable at 0.1 pounds, suitable for stocking in a service kit
• Sold individually, allowing single-unit replacement per service visit
• Designed to maintain a leak-free seal under normal closed-loop system operating pressures

Compatibility

Designed for use with 10 MicroMag magnetic filtration units as specified by ECLIPSE. Verify housing model and O-ring seat diameter before installation to confirm fitment.

Installation Notes

Installation should be performed by a licensed plumber or HVAC technician familiar with closed-loop hydronic systems. Isolate and depressurize the filtration assembly and allow the system to cool before opening the filter housing. Inspect the O-ring seating groove for debris or damage and clean it thoroughly before installing the new O-ring. Do not reuse the old O-ring after housing disassembly, as compression set will prevent a reliable reseal.