Eaton lt250 Liquidtight Conduit Connector 2-1/2 Inch

Product Description

The EATON lt250 is a straight liquidtight conduit connector designed for use with flexible metal conduit (FMC). Constructed from malleable iron, this connector provides a secure, moisture-resistant termination point where FMC meets an enclosure, junction box, or panel knockout. It is rated for 2-1/2 inch trade size conduit and measures 3.19 inches in length with a 4-inch width and 4-inch height. Electricians install this fitting in commercial and industrial applications where a reliable, liquid-resistant seal is required at the conduit-to-box connection.

This connector is suited for use in wet or damp locations where FMC terminations must resist moisture ingress. It is commonly installed in commercial buildings, industrial facilities, and mechanical rooms at equipment panels, motor connections, and enclosure entries. The straight configuration is appropriate when the conduit run approaches the knockout at a direct angle, minimizing the need for additional bends or offsets in the raceway system.

Key Features

• Straight angle configuration for direct conduit-to-enclosure terminations
• 2-1/2 inch trade size accommodates standard FMC of the same size
• Malleable iron construction for durability in demanding environments
• Liquidtight design provides moisture-resistant seal at the connection point
• 3.19 inch length with 4 inch width and 4 inch height for consistent fitment in standard knockout layouts

Compatibility

Designed for use with 2-1/2 inch trade size flexible metal conduit (FMC) in standard liquidtight conduit connector applications.

Installation Notes

Installation is performed by a licensed electrician in accordance with applicable NEC requirements for liquidtight fittings in wet or damp locations. De-energize all circuits and verify the panel or enclosure is locked out before beginning work. Hand-tighten the connector into the knockout, then use the appropriate conduit fitting wrench to secure without over-torquing the malleable iron body. Confirm the locknut is properly seated against the enclosure wall to maintain the liquidtight seal.