Eagle Cutting Tool RBCS-11250-OP Sds Plus Rebar Cutter

Product Description

The EAGLE CUTTING TOOL RBCS-11250-OP is an SDS Plus rebar cutter bit designed for cutting through steel rebar embedded in concrete. At 1.125 inches in diameter and 12 inches in length, this bit provides the reach and cutting diameter needed for demanding core and penetration work. It fits SDS Plus rotary hammer drills, which are standard equipment for concrete trades. Electricians, plumbers, and general contractors use this type of bit when routing conduit, pipe, or anchor work through reinforced concrete slabs and walls.

This bit is suited for commercial and residential construction applications where rebar-reinforced concrete is present. Typical scenarios include core drilling through foundation walls, concrete floors, or structural slabs where standard masonry bits would fail on contact with embedded steel. The 12-inch length allows for adequate penetration depth on most standard slab and wall thicknesses without requiring an extension.

Key Features

• SDS Plus shank for compatibility with standard rotary hammer drills
• 1.125-inch cutting diameter suited for conduit and anchor pass-through work
• 12-inch length provides sufficient depth for standard slab and wall penetrations
• Designed to cut through steel rebar without bit failure or stalling
• Single-piece construction for straightforward deployment on the job site

Compatibility

Designed as a direct-fit accessory for SDS Plus rotary hammer drills used in rebar-reinforced concrete cutting and core drilling applications.

Installation Notes

Installation and operation of this bit should be performed by a qualified tradesperson familiar with rotary hammer drill operation and concrete core drilling procedures. Always ensure the rotary hammer is powered off and the shank is fully seated and locked before drilling. Wear appropriate PPE including eye protection and hearing protection when operating SDS Plus equipment in concrete. Follow applicable OSHA safety guidelines for concrete drilling in occupied or structural settings.

Technical Specifications

• Shank Type: SDS Plus
• Cutting Diameter: 1.125 inches
• Overall Length: 12 inches
• Weight: 4.87 pounds

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: RBCS-11250-OP