E.r. Wagner 1F5902709T08110 Stem Mount Caster 200 Lb

Product Description

The E.R. WAGNER 1F5902709T08110 is a stem mount standard caster designed for light-duty rolling applications in electronic and business equipment. The wheel measures 2 inches in diameter and 13/16 inches wide, with an overall assembly height of 2-3/4 inches. It carries a rated load capacity of 200 pounds and mounts via a 1/2-13 x 1-1/2 inch threaded stem. The wheel is constructed from hard rubber, suited for smooth, hard floor surfaces, and the bore uses a Delrin bearing for low-maintenance rotation. The zinc-finished yoke and hardened, heat-treated construction add durability in regular service. Installers in equipment maintenance and light industrial settings will find this caster ready to mount without modification.

This caster is intended for use on electronic and business equipment where a compact, fixed stem mount is required. The threaded stem configuration allows direct installation into pre-tapped equipment frames or leg sockets. The hard rubber wheel is appropriate for indoor hard floor surfaces, providing quiet operation without marking. At 2-3/4 inches overall assembly height, this unit fits low-clearance equipment bases. It is a practical choice for office equipment, instrument carts, and similar light-duty rolling platforms common in facilities maintenance work.

Key Features

• 200-pound load capacity for light-duty equipment support
• Hard rubber wheel, 2 inches diameter x 13/16 inches wide, for quiet indoor floor use
• Delrin bearing for smooth, low-maintenance wheel rotation
• 1/2-13 x 1-1/2 inch threaded stem for direct installation into tapped sockets
• Hardened, heat-treated construction with zinc finish for durability
• 2-3/4 inch overall assembly height suits low-clearance equipment bases

Compatibility

Designed as a standard threaded stem mount caster for electronic and business equipment applications requiring a 1/2-13 threaded stem and a 2-inch hard rubber wheel.

Installation Notes

Installation is typically performed by equipment maintenance technicians or facilities staff. Before installing or replacing casters, ensure the equipment is powered down, unplugged, and fully supported to prevent tipping. Thread the stem into the receiving socket by hand first, then tighten with the appropriate wrench to the equipment manufacturer's specification. Verify load rating is not exceeded when all casters are installed under the equipment.