Diversitech 7441 Liquid Tight Conduit 3/4 Inch 100 Foot

Product Description

The DIVERSITECH 7441 is a 3/4-inch liquid tight non-metallic flexible conduit supplied in a 100-foot roll. It protects electrical wiring from moisture, chemicals, and physical impact in demanding field environments. The conduit is rated to 176 degrees F in dry conditions, 140 degrees F in wet conditions, and 158 degrees F in oil-exposure environments, making it a dependable choice for HVAC wiring runs and transformer connections. At 16 pounds per roll, it is sized for straightforward handling and routing on the job. Licensed electricians and HVAC technicians install this conduit during equipment commissioning and service calls where flexible, moisture-resistant wire protection is required by code.

This conduit is used in residential and light commercial air conditioning, heating, and transformer connection applications. Its flexibility allows technicians to route wiring around equipment housings, through tight spaces, and along irregular mounting surfaces without rigid conduit fittings. The 100-foot roll length is standard for typical equipment installations and reduces mid-run splicing. It meets NEC 1987 standards and carries UL and CUL listings, satisfying common inspection requirements on both domestic and Canadian job sites.

Key Features

• 3/4-inch trade size in a 100-foot roll — standard length for HVAC and transformer wiring runs
• Rated 176 degrees F dry, 140 degrees F wet, and 158 degrees F in oil environments
• Impact resistant, chemical resistant, and UV resistant construction
• UL and CUL listed — meets NEC 1987 applicable standard
• Flexible non-metallic design for routing in tight or irregular spaces
• Liquid tight construction keeps moisture out of wire runs in exposed or outdoor installs

Compatibility

Suitable for air conditioning, heating, and transformer connection wiring applications requiring liquid tight non-metallic flexible conduit at 3/4-inch trade size.

Installation Notes

This conduit is installed by licensed electricians or HVAC technicians in accordance with applicable NEC requirements for liquid tight flexible non-metallic conduit. De-energize all circuits and confirm power is off at the disconnect before routing or terminating wiring inside the conduit. Use fittings rated for liquid tight non-metallic conduit to maintain the moisture seal at both ends. Avoid bending the conduit below its minimum bend radius, which can stress the inner liner and compromise protection.