Dewalt dwe7485ws Portable Table Saw 15A 120V

Product Description

The DEWALT dwe7485ws is a corded portable table saw designed for jobsite use by carpenters, finish contractors, and general tradespeople who need accurate rip and crosscut capacity at a worksite without a permanent shop setup. Running on 120 volts AC and drawing 15 amps, it delivers consistent power for dimensional lumber, sheet goods, and trim cuts. The saw ships with a folding stand that elevates the unit to a comfortable working height, reducing setup time on the job. The stand detaches from the saw body and folds flat for transport or storage in a work van or truck bed.

This saw is suited to residential and light commercial construction environments where portability matters as much as cut quality. The rip fence adjusts from 12.5 inches left to 24.25 inches right of the blade, giving the operator a wide range of rip widths without a secondary fence setup. Bevel capacity runs from -2 degrees to 47 degrees, covering standard and compound bevel cuts on framing, decking, trim, and similar materials. It is a one-person setup that does not require a permanent mounting surface.

Key Features

• Corded 120-volt AC operation with 15-amp draw for consistent jobsite power
• Rip capacity: 12.5 inches left to 24.25 inches right of blade
• Bevel range: -2 degrees to 47 degrees for compound angle cuts
• Included folding stand elevates saw to working height and detaches for compact storage
• Portable design built for transport between jobsites

Compatibility

Designed as a self-contained portable table saw unit. Accessory compatibility, including dado sets and replacement blades, should be verified against the DEWALT dwe7485ws owner documentation before installation.

Installation Notes

Setup and operation should be performed by a qualified tradesperson familiar with table saw safety procedures. Disconnect power before changing blades, adjusting the fence, or making any mechanical adjustments to the saw or stand. Verify that the stand is fully locked before placing the saw under load. Operate in accordance with applicable OSHA jobsite safety standards and local regulations.

Technical Specifications

• Voltage: 120 volts AC
• Amperage: 15 amps
• Rip Capacity Left: 12.5 inches
• Rip Capacity Right: 24.25 inches
• Bevel Range: -2 degrees to 47 degrees
• Power Source: Corded

Standard Information

• Brand: DEWALT
• Manufacturer Part Number: dwe7485ws