Dewalt Accessories DWARAFS Right Angle Flex Shaft

Product Description

The DEWALT ACCESSORIES DWARAFS is a 12 inch right angle flex shaft attachment designed for drills and drivers operating in confined or obstructed work areas. The head delivers a true 90 degree angle, letting technicians drive fasteners in spaces where a straight drill cannot reach. A Rapid Load design speeds up bit changes without extra tools, and an integrated magnet holds the fastener in place during seating for consistent alignment. The 1/4 inch hex shank fits any standard 1/4 inch driver or drill chuck. A side handle provides additional leverage and control during operation.

This attachment is suited for electricians, HVAC installers, plumbers, and general construction trades who routinely work inside wall cavities, above drop ceilings, inside mechanical chases, or around framing members where a standard drill cannot be positioned. The flexible shaft allows the operator to route the shaft around obstructions while maintaining torque transmission to the bit. The 12 inch length adds reach into deep cavities without requiring extended drill bits.

Key Features

• True 90 degree right angle head for driving fasteners in tight or restricted spaces
• Rapid Load head design allows quick bit changes without extra tools
• Magnetic fastener retention supports 100 percent alignment before and during driving
• 12 inch flexible shaft extends reach into deep or obstructed cavities
• Side handle provides added leverage and reduces torque reaction during use
• 1/4 inch hex shank accepts any standard 1/4 inch shank driver bit

Compatibility

Designed for use with any drill or driver equipped with a 1/4 inch hex chuck or 1/4 inch bit-holder collet, making it compatible with a wide range of corded and cordless drill platforms commonly used in trade applications.

Installation Notes

Installation is performed by any trade professional using a compatible 1/4 inch hex chuck drill or driver. Ensure the drill is powered off and the trigger is locked out before inserting or removing the shaft from the chuck. Verify the bit is fully seated in the Rapid Load head before applying torque. Do not exceed the torque rating of the drive bit in use, as the flex shaft transmits full driver torque to the bit.