Dewalt Accessories DWAF2PH3IR3 Phillips 3 Bit 3 Pack

Product Description

The DEWALT ACCESSORIES DWAF2PH3IR3 is a 3-pack of 2.25-inch Phillips 3 impact screwdriving bits designed for use with drills and impact drivers on job sites where fastener speed and bit longevity matter. Each bit features a redesigned tip geometry that improves fitment on PH3 fasteners and an integrated FLEXTORQ Zone that flexes under torsional load to absorb impact energy, extending bit service life. The 1/4-inch hex shank is impact-ready and seats in standard quick-change chucks. Laser-etched size markings keep the bit identifiable through heavy use. These bits are installed by electricians, HVAC technicians, plumbers, carpenters, and general tradespeople who rely on impact-rated accessories for production work.

The DWAF2PH3IR3 is suited for residential and light commercial construction and service work where PH3 fasteners are common, including panel installations, equipment mounting, and structural fastening tasks. The 3-pack format is practical for tool pouches and service kits. Because bit failure mid-task is a time and cost problem on service calls, the FLEXTORQ Zone design targets the cam-out and shank fracture failures common with standard bits under high-torque impact drivers.

Key Features

• FLEXTORQ Zone absorbs torsional impact to extend bit life
• Redesigned PH3 tip geometry for improved fastener fitment and reduced cam-out
• 2.25-inch length suits standard depth applications with impact drivers and drills
• 1/4-inch hex shank fits all standard quick-change chucks
• Laser-etched size identification remains legible through extended use
• Sold as a 3-pack for practical job site stocking

Compatibility

Designed for use with impact drivers and drills equipped with a standard 1/4-inch hex quick-change chuck. Intended for PH3 Phillips fasteners.

Installation Notes

Seat the 1/4-inch hex shank fully into the chuck before driving. These bits are rated for impact driver use, but should not be used in a drill press or right-angle drive without confirming impact rating compatibility. Inspect bits for tip wear before each use, as a worn PH3 tip increases cam-out risk and fastener damage. Follow applicable trade codes for fastener torque requirements on structural or electrical panel applications.