Devcon 14355 Two-part Epoxy 400 Ml Cartridge Adhesive

Product Description

The DEVCON 14355 is a two-part structural epoxy adhesive packaged in a 400 mL cartridge with a 1:1 mixing ratio. It delivers a working time of 8 to 12 minutes and reaches fixture in 30 to 35 minutes, with full cure achieved in 2 hours. The adhesive produces a clear bond and is formulated to be water-resistant, making it suitable for demanding repair and fabrication work across HVAC, plumbing, electrical, and general mechanical trades. It meets ASTM D-1002 shear strength testing standards and carries a rated shear strength of 2,250 psi, placing it in the 2 Ton series product line.

This epoxy is appropriate for bonding a wide range of substrates including ceramic, concrete, glass, metal, and wood. It fits residential and commercial maintenance, equipment repair, and fabrication scenarios where a strong, fast-setting structural adhesive is required. The cartridge format is designed for use with a standard dual-component dispensing gun, enabling consistent metering and mix ratio control without manual measuring. The operating temperature range of -40 to 200 degrees F makes it viable in both cold-environment installations and high-temperature service locations common in mechanical rooms and rooftop applications.

Key Features

• 1:1 mix ratio cartridge format for consistent, mess-free dispensing
• 8 to 12 minute working time with fixture in 30 to 35 minutes
• Full cure in 2 hours for faster return to service
• 2,250 psi shear strength per ASTM D-1002
• Water-resistant bond suitable for wet or humid environments
• Bonds to ceramic, concrete, glass, metal, and wood
• Operating range of -40 to 200 degrees F

Compatibility

Designed as a structural bonding adhesive for use on ceramic, concrete, glass, metal, and wood substrates across a broad range of repair and fabrication applications in the trades.

Installation Notes

Application should be performed by a qualified technician familiar with structural adhesives and applicable safety requirements. Surfaces must be clean, dry, and free of oil, grease, and loose material before application. A dual-component cartridge dispensing gun is required to maintain the 1:1 mix ratio. Allow full 2-hour cure time before applying load or stress to the bonded assembly.