Deltana BDS125U10B Baseboard Door Bumper Solid Brass

Product Description

The DELTANA BDS125U10B is a solid brass baseboard door bumper finished in oil rubbed bronze. It mounts at the base of a wall to stop a swinging door before the knob or edge contacts the baseboard or drywall. At 1.5 inches in length and 0.09 pounds, it is a low-profile, unobtrusive solution for residential and light commercial door protection. The solid brass construction provides long-term durability, and the oil rubbed bronze finish coordinates with matching door hardware sets. Installation requires only basic hand tools and takes minutes per unit. Carpenters, finish contractors, and door hardware installers are the primary trades that specify and install this type of hardware.

This baseboard door bumper is suited for interior residential and light commercial applications where wall or baseboard protection is needed. It is typically installed on standard interior door swings in rooms where door stops mounted to the floor or hinge are not practical or preferred. The low-profile design makes it appropriate for high-traffic rooms, rental units, and retrofit installations where a clean, finished look is required.

Key Features

• Solid brass construction for corrosion resistance and long service life
• Oil rubbed bronze finish for a consistent look with coordinating hardware sets
• Low-profile footprint at 1.5 inches long and 0.2 inches high
• Lightweight at 0.09 pounds, adding no stress to wall surfaces
• Sold individually, allowing single-unit replacement or multi-door installs as needed

Compatibility

Designed as an OEM-style replacement or new-installation baseboard door bumper for standard interior residential and light commercial door applications.

Installation Notes

Installed by carpenters, finish contractors, or general tradespeople as part of door hardware finish work. Power down any adjacent low-voltage systems if drilling near wired baseboard components. Use a properly sized screw anchor when mounting into drywall between studs to ensure a secure hold. Do not overtighten the mounting fastener, as solid brass hardware can strip if excessive torque is applied.