De-sta-co 802-UE Pneumatic Hold Down Toggle Clamp

Product Description

The DE-STA-CO 802-UE is a pneumatic hold down toggle clamp designed for industrial workholding applications where air-actuated clamping force is required. It delivers an inner holding capacity of 200 pounds (890 N) and an outer clamping force of 235 pounds (1045 N), operating at a maximum air pressure of 145 psi (10 bar). The solid bar opens to 102 degrees, and the height under bar measures 1.06 inches. A G1/8 port connects to the pneumatic supply line. The spindle assembly is included. This clamp is typically installed by industrial maintenance technicians, tooling engineers, or fixture builders in production and assembly environments.

The 802-UE is suited for horizontal mounting on jigs, fixtures, and production tooling where repeatable pneumatic clamping is needed. The closed bar style and pneumatic actuation make it appropriate for automated or semi-automated assembly lines where manual toggle operation is not practical. The clamp supports Round and T-Slot sensor compatibility, allowing integration with position-sensing systems for cycle verification in manufacturing cells.

Key Features

• 200 lb inner holding capacity and 235 lb outer clamping force for reliable workpiece retention
• Pneumatic actuation with G1/8 port - no manual toggle operation required
• 102-degree bar opening provides clear workpiece access during load and unload cycles
• Solid bar style with 1.06-inch height under bar accommodates a range of workpiece thicknesses
• Compatible with Round and T-Slot sensors for automated cycle detection
• Spindle assembly included - no additional hardware required for basic installation

Compatibility

Designed as an OEM-style pneumatic hold down toggle clamp for use on industrial jigs, fixtures, and workholding assemblies requiring horizontal mounting and air-actuated clamping.

Installation Notes

Installation is typically performed by tooling or maintenance technicians familiar with pneumatic circuit design. Disconnect and lockout the air supply before mounting or servicing the clamp. Mounting holes are sized for 0.22-inch fasteners with a 0.50-inch length spacing and 1.06-inch width spacing between centers - verify fixture plate layout before drilling. Ensure the operating air pressure does not exceed 145 psi and that the supply line is properly filtered and regulated per the equipment manufacturer's requirements.