Dan-loc Bolt Gasket CSPB8.075C0350E Fully Threaded Stud

Product Description

The DAN-LOC BOLT GASKET CSPB8.075C0350E is a fully threaded stud manufactured from 304 stainless steel to ASTM B8 standards. The stud features a 3/4-10 UNC thread form and measures 3.5 inches in overall length, with threading running the full length of the fastener. The uncoated finish preserves the natural corrosion resistance of the 304 alloy, making it well suited for wet, chemical, or outdoor service environments. Licensed tradespeople working in plumbing, mechanical, and industrial installation rely on fully threaded studs like this one for flange connections, equipment mounting, and structural fastening where a nut is required at both ends of the joint.

This stud is appropriate for general mechanical and trade applications where a 3/4-10 thread pattern is specified. Typical use cases include pipe flange assembly, pump mounting, and equipment hold-down in residential and commercial mechanical rooms. The 304 stainless construction suits applications exposed to moisture, mild chemicals, or outdoor conditions where carbon steel fasteners would corrode prematurely. The ASTM B8 designation confirms the material and mechanical property requirements have been met for this grade and thread size.

Key Features

• Fully threaded along the entire 3.5-inch length - no unthreaded shank to align with joint stack-up
• 3/4-10 UNC thread size for standard nuts and coupling hardware
• 304 stainless steel construction for corrosion resistance in wet and chemical environments
• Uncoated finish - no plating to chip, flake, or introduce contamination
• Meets ASTM B8 material and mechanical standards
• Weighs approximately 0.36 pounds per unit

Compatibility

Designed for use with standard 3/4-10 UNC hex nuts, coupling nuts, and flanged hardware in mechanical, plumbing, and industrial fastening applications where ASTM B8 Grade 304 stainless studs are specified.

Installation Notes

Installation is typically performed by licensed plumbers, pipefitters, or mechanical contractors. De-energize and depressurize any system before removing or installing flange fasteners. Use appropriate stainless-compatible anti-seize compound on threads to prevent galling, which is common with 304 stainless fasteners under torque. Follow the applicable ASME, IFGC, or IPC code requirements for fastener grade and torque sequence when assembling flanged joints.