Dan-loc Bolt Gasket CSP188050C0250E Fully Threaded Stud

Product Description

The DAN-LOC BOLT GASKET CSP188050C0250E is a fully threaded stud used to fasten components in mechanical, plumbing, HVAC, and structural assemblies. It features a 1/2-13 Unified National Coarse (UNC) thread and a 2.5-inch overall length. Manufactured from 18-8 stainless steel with an uncoated plain finish, this stud offers good corrosion resistance in wet or chemically active environments. Fully threaded along its entire length, it accepts nuts on both ends, making it suitable for through-bolting or double-nut applications. Licensed tradespeople and maintenance technicians commonly use these studs wherever a standard hex bolt cannot be installed due to space or access constraints.

This fully threaded stud is suited for residential and light commercial mechanical installations including pipe support bracketing, equipment mounting, and flange connections. Its 1/2-13 thread is a widely used size across HVAC equipment frames, plumbing fixtures, pump assemblies, and general structural fastening. The uncoated stainless steel finish makes it appropriate for indoor and outdoor use where rust resistance is a priority without the need for plated or coated hardware.

Key Features

• Fully threaded design allows nut engagement at both ends for through-bolting or stud-mounted applications
• 1/2-13 UNC thread size is a common standard across HVAC, plumbing, and mechanical equipment
• 18-8 stainless steel construction provides corrosion resistance in wet and outdoor environments
• 2.5-inch overall length suits typical panel, bracket, and flange fastening tasks
• Uncoated finish is compatible with standard stainless hardware without galvanic mismatch concerns when paired with same-material nuts and washers

Compatibility

Designed as a standard 1/2-13 UNC fully threaded stud for use with compatible 1/2-13 nuts and hardware in mechanical, plumbing, and HVAC fastening applications.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or mechanical contractors following applicable codes. De-energize and depressurize any system before replacing or installing fasteners in live assemblies. Use stainless steel nuts and washers to avoid galvanic corrosion. Do not cross-thread or over-torque; use a calibrated torque wrench per the equipment manufacturer's fastener specifications.