Dan-loc Bolt Gasket 110-05-035 Fully Threaded Stud

Product Description

The DAN-LOC BOLT GASKET 110-05-035 is a fully threaded stud machined from 304 stainless steel with a 5/8-11 unified coarse thread and an overall length of 3.5 inches. The uncoated finish leaves the stainless material exposed, which provides natural corrosion resistance without an additional plating process. This stud meets ASTM B8 standards, confirming it is produced from austenitic stainless rod stock. Fully threaded studs are used when a fastener must engage two mating components - such as a nut on each end or a tapped hole on one end - without a plain shank section. Plumbers, pipefitters, HVAC technicians, and mechanical contractors install this type of hardware in flanged connections, equipment mounting, and structural assemblies where corrosion resistance is a priority.

This stud is appropriate for residential and commercial mechanical applications where 5/8-11 thread engagement is required and where stainless steel is specified for moisture, chemical, or temperature exposure. Typical use cases include pipe flange bolt-up, pump and blower mounting, and general equipment fastening in corrosive environments. The 3.5-inch overall length suits moderate-depth through-bolt and stud-mount configurations commonly encountered in HVAC equipment, plumbing manifolds, and industrial support frameworks.

Key Features

• 304 stainless steel construction provides corrosion resistance in wet and chemically active environments
• 5/8-11 unified coarse thread for broad compatibility with standard nuts and tapped components
• 3.5-inch overall length suits through-bolt and double-nut fastening configurations
• Fully threaded along entire length - no plain shank - allowing flexible positioning of mating hardware
• Meets ASTM B8 standard for stainless steel fasteners
• Uncoated finish maintains material integrity without plating buildup that could affect thread fit

Compatibility

Designed as a standard 5/8-11 fully threaded stud for use with any compatible 5/8-11 hex nut, coupling nut, or tapped hole conforming to unified coarse thread specifications.

Installation Notes

Install by a qualified mechanic, pipefitter, or HVAC technician in accordance with applicable mechanical codes and equipment manufacturer torque requirements. De-energize and depressurize any system before replacing or installing studs in flanged or pressurized assemblies. Use a stud driver or double-nut method to thread the stud into tapped holes without damaging the thread form. Inspect mating threads for corrosion or damage before installation to ensure proper engagement and load distribution.