Dan-loc Bolt Gasket 110-05-025 Threaded Stud 5/8-11

Product Description

The DAN-LOC BOLT GASKET 110-05-025 is a fully threaded stud machined from Grade 304 stainless steel to ASTM B8 standards. It features a 5/8-11 UNC thread form running the full 2.5-inch overall length with an uncoated plain finish. Fully threaded studs like this one are used where a bolt head would interfere with assembly or where double-nut torquing is required. The Grade 304 stainless construction resists corrosion in wet, chemical-adjacent, and outdoor environments, making this fastener a reliable choice for mechanical, plumbing, and HVAC structural connections that demand material traceability and dimensional consistency.

This stud is suited for general industrial and trade applications including pipe flange assemblies, equipment mounting, and structural bracketing where a headless, fully threaded fastener is specified. It is sold individually, making it practical for repair and replacement work where only a single fastener is needed without committing to bulk quantities.

Key Features

• Fully threaded 5/8-11 UNC thread along the entire 2.5-inch length
• Grade 304 stainless steel construction for corrosion resistance
• Meets ASTM B8 standard for stainless steel fasteners
• Uncoated plain finish for direct use or field coating
• Sold as a single unit with a minimum order quantity of 1

Compatibility

Designed as a standard 5/8-11 UNC fully threaded stud for use in mechanical assemblies, pipe flanges, and equipment mounting applications requiring a Grade 304 stainless steel fastener to ASTM B8 specifications.

Installation Notes

Installation is typically performed by a licensed mechanical contractor or qualified tradesperson using appropriate thread engagement depth and double-nut torquing technique. Always verify that mating hardware - including nuts and washers - is compatible with 5/8-11 UNC threading and is rated for the same material grade to avoid galvanic corrosion. De-energize and depressurize any system before replacing fasteners in pressurized assemblies. Follow applicable codes and equipment manufacturer torque guidelines for the specific application.