Dan-loc Bolt Gasket 000-05-080 Fully Threaded Stud

Product Description

The DAN-LOC BOLT GASKET 000-05-080 is a fully threaded stud machined from Grade B7 alloy steel with an uncoated plain finish. It carries a 5/8-11 UNC thread form across its entire 8-inch overall length, providing consistent thread engagement for both mating nuts along the full shaft. Grade B7 alloy steel is a high-strength material widely specified in industrial fastener applications where elevated tensile strength and reliable clamping force are required. Tradespeople and maintenance technicians use fully threaded studs where bolt access from one side is limited or where a double-nut installation method is preferred over a standard hex bolt.

This fully threaded stud is suited for structural, mechanical, and industrial assembly applications that call for a 5/8-11 threaded fastener. Typical use cases include flange connections, equipment mounting, jig and fixture builds, and general mechanical assembly in industrial and trade environments. The 8-inch overall length provides adequate thread engagement depth for thicker flanges, standoff assemblies, or stacked component installations. The uncoated plain finish is appropriate for dry or protected indoor installations; additional corrosion protection such as plating or coating can be applied by the installer if the service environment requires it.

Key Features

• Fully threaded along the entire 8-inch length for maximum nut positioning flexibility
• 5/8-11 UNC thread form for compatibility with standard 5/8-inch nuts and hardware
• Grade B7 alloy steel construction for high tensile strength in demanding fastener applications
• Uncoated plain finish suitable for dry or protected service environments
• Consistent thread form across the full length supports double-nut locking installations

Compatibility

Designed as a fully threaded stud replacement or component fastener for any application requiring a 5/8-11 UNC threaded stud in Grade B7 alloy steel at 8 inches overall length.

Installation Notes

Installation is typically performed by millwrights, pipefitters, or maintenance mechanics using standard 5/8-inch hex nuts and appropriate hand or power tools. Always verify thread engagement depth meets the design requirement before torquing. Apply a thread lubricant or anti-seize compound if specified for the service environment. Do not over-torque; consult the applicable structural or mechanical design specification for the correct torque value for this stud size and grade.