Dan-loc 000-05-060 Fully Threaded Stud 5/8-11 6 in B7

Product Description

The DAN-LOC BOLT GASKET 000-05-060 is a fully threaded stud machined from Grade B7 alloy steel with an uncoated plain finish. It measures 6 inches overall length with a 5/8-11 UNC thread form running the full length of the shank. Grade B7 alloy steel is the standard material for high-strength fastener applications, offering elevated tensile and yield strength compared to standard carbon steel. The uncoated finish makes it suitable for use where coatings could interfere with thread fit or where field coating will be applied. Weighing 0.71 pounds, this stud is a single-piece fastener used in mechanical assemblies, pipe flanges, equipment mounting, and structural connections across HVAC, industrial, and plumbing applications.

Fully threaded studs in this size range are commonly used in flange connections, equipment base mounting, and pressure vessel assemblies in commercial and industrial settings. Licensed plumbers, pipefitters, millwrights, and mechanical contractors typically install this type of fastener when assembling flanged pipe joints, securing pumps, or mounting large equipment skids. The 5/8-11 thread size is a standard coarse-thread designation that accepts widely available nuts and threaded inserts of the same specification.

Key Features

• Grade B7 alloy steel construction for high tensile strength in demanding applications
• Full 5/8-11 UNC thread along the entire 6-inch length for maximum engagement flexibility
• Uncoated finish compatible with field-applied coatings or bare installation
• Single-piece stud design eliminates the need for bolt head clearance in confined assemblies
• Weighs 0.71 pounds - appropriate for torque tool selection and load calculations

Compatibility

Designed as a standard replacement or new-installation fully threaded stud for any assembly requiring a 5/8-11 UNC thread and 6-inch overall length in Grade B7 alloy steel.

Installation Notes

Installation is typically performed by licensed pipefitters, plumbers, or mechanical contractors following applicable ASME, IFGC, or facility-specific torque and assembly standards. De-energize or depressurize the system fully before replacing studs in pressurized assemblies. Use calibrated torque equipment appropriate for Grade B7 fasteners and apply thread lubricant or anti-seize compound as required by the joint specification. Inspect mating nut threads for wear or damage before assembly.