Crc 02133 Qd Contact Cleaner 14 Oz Spray

Product Description

The CRC 02133 QD Contact Cleaner is a fast-evaporating electrical contact cleaner formulated for sensitive electronics and electrical equipment. Packaged in a 14 fl oz aerosol spray can, it delivers a targeted stream that flushes away dirt, oil, flux residue, and moisture from contacts, connectors, circuit boards, and switches. The formula leaves zero residue after evaporation, which is critical when servicing live or energized components where contamination from cleaning agents can cause failure or tracking. HVAC technicians, electricians, and electronics service pros reach for QD contact cleaner during control board inspection, relay servicing, and sensor cleaning tasks.

This cleaner is suited for residential and light commercial applications where electrical and electronic components require routine maintenance or fault diagnosis. It is appropriate for use on motor control centers, thermostats, contactors, printed circuit boards, and other low-voltage and line-voltage assemblies. The formula is rated safe on all plastics, making it compatible with a wide range of enclosure materials and connector housings commonly found in HVAC controls and panel wiring. It carries NSF K2 registration, making it acceptable for use in food-processing facility maintenance applications.

Key Features

• Fast evaporation with no residue left on treated surfaces
• Safe for use on all plastic materials and connector housings
• NSF K2 Registered for use in food-processing environments
• 14 fl oz aerosol spray can for targeted, controlled application
• Suitable where lower flash-point cleaners are acceptable
• Removes oil, dirt, flux, and moisture from electrical contacts and circuit boards

Compatibility

Designed for use on sensitive electronics and electrical equipment including contacts, connectors, relays, switches, and printed circuit boards where a fast-evaporating, residue-free cleaner is required.

Installation Notes

Electrical and HVAC technicians should de-energize equipment before applying contact cleaner whenever safe and practical to do so. Apply in a well-ventilated area away from open flames or ignition sources, as this product is extremely flammable with a flash point below 0 degrees F. Allow full evaporation before re-energizing any component. Follow applicable NEC guidelines and facility safety protocols when servicing electrical enclosures.