Cratex W216A120CXG 1/8 Mounted Point 120 Grit Cylinder

Product Description

The CRATEX W216A120CXG 1/8 is a rubber-bonded aluminum oxide mounted point designed for precision grinding, deburring, and surface finishing in tight or contoured areas. It features a cylinder (W216) profile, 120 grit abrasive at a fine grade, and a soft density formulation that conforms slightly to workpiece geometry for consistent material removal. The 1/8-inch shank mounts directly into standard die grinders, rotary tools, and flexible-shaft machines. Maximum rated speed is 12,750 RPM. This type of mounted point is a standard consumable in metal fabrication, tool and die, and maintenance shops where controlled, low-heat abrasive work is required.

This mounted point is suited for internal diameter work, slot finishing, port blending, and deburring on ferrous and non-ferrous metals, as well as hardened steel components. The fine 120 grit finish makes it appropriate for final-pass stock removal and light surface conditioning rather than heavy rough grinding. It fits any die grinder or rotary tool that accepts a 1/8-inch collet or chuck, making it a common choice for HVAC technicians, pipefitters, millwrights, and metalworkers needing a compact abrasive for hard-to-reach locations.

Key Features

• Cylinder (W216) point shape for consistent contact on flat, internal, and contoured surfaces
• 120 grit aluminum oxide abrasive at fine grade for controlled material removal and surface conditioning
• Soft density bond allows slight workpiece conformity and reduces heat buildup
• Rated to 12,750 RPM for use with standard die grinders and rotary tools
• 1/8-inch shank diameter fits widely available collets and chucks with no adapter needed
• Compact 1/4-inch head thickness suited for tight clearances and precision applications

Compatibility

Designed for use with die grinders, rotary tools, and flexible-shaft machines that accept a 1/8-inch shank. Do not exceed the rated speed of 12,750 RPM.

Installation Notes

Install the shank fully into the collet or chuck before tightening, and confirm the tool is rated for at least the RPM of this mounted point before use. Always power down and disconnect the tool from its power source before changing mounted points. Wear appropriate eye protection and follow applicable ANSI B7.1 safety standards for abrasive product use. Inspect the mounted point for cracks or damage before each use and discard if any are found.