Continental Contitech 20042082 V-belt Section B 67 in B64

Product Description

The CONTINENTAL CONTITECH 20042082 is a Section B classical V-belt designed for power transmission in HVAC, industrial fan, and mechanical drive applications. Constructed from Wingprene rubber-impregnated fabric, this belt delivers reliable flex and heat resistance across a wide operating temperature range of -40 degrees F to 284 degrees F (-40 C to 140 C). With a 67.0-inch outside length and an internal length of 65.80 inches, it conforms to the B64 belt designation. This belt weighs 0.7 pounds and is a direct fit for standard B-section sheaves and pulleys used throughout trade and light-industrial equipment.

Section B V-belts are a standard belt profile found in residential and commercial HVAC systems, refrigeration condenser fan drives, air handling units, and general mechanical equipment. The B64 designation identifies this as a belt with 67 inches of outside circumference, fitting standard B-section grooved sheaves commonly found on blower assemblies, compressors, and pump drives. Licensed HVAC technicians, millwrights, and mechanical contractors install this type of belt as a routine maintenance replacement on belt-driven fan and blower systems.

Key Features

• Section B profile with 67.0-inch outside length and 65.80-inch internal length for standard B64 fitment
• Wingprene rubber-impregnated fabric construction for flex durability and oil resistance
• Wide operating range from -40 degrees F to 284 degrees F supports demanding environments
• HY-T Matchmaker style design for consistent cross-section geometry in matched-set applications
• Single-belt packaging with an MOQ of 1 for replacement and service use

Compatibility

Designed as a standard OEM-style replacement for Section B V-belt applications requiring a B64 belt. Fits any standard B-section grooved sheave or pulley system rated for this outside length.

Installation Notes

Belt-driven systems must be de-energized and locked out before belt removal or installation. HVAC technicians should verify sheave alignment with a straightedge or laser tool before installing the new belt to prevent premature wear. Adjust drive tension per equipment manufacturer specifications after installation, then re-check tension after initial run-in. Do not pry belts over sheave flanges, as this can damage the belt cord structure.