Continental Contitech 20025487 Oil Resistant Air Hose

Product Description

The CONTINENTAL CONTITECH 20025487 is a red rubber oil-resistant air hose designed for compressed air service in shops, industrial facilities, and trade environments where petroleum exposure is a concern. Built with a 3/8 inch inside diameter and rated to 200 working psi, it handles the demands of pneumatic tools and equipment commonly found in HVAC, plumbing, and general mechanical service work. The hose operates across a wide temperature range of -20 to 190 degrees F, making it suitable for both indoor and seasonal outdoor applications. It is sold in cut-to-length increments with a 25-foot minimum cut length from a 500-foot total coil.

This hose is well-suited for use in commercial shops, service vehicles, and job sites where air lines are run to pneumatic tools, blow guns, or inflation equipment. The oil-resistant construction resists degradation from compressor oil carryover and incidental petroleum contact. It is ordered in 1-foot increments with a minimum cut of 25 feet, allowing tradespeople to purchase only what the job requires. End connections are not included and must be field-installed to match the specific fitting configuration needed.

Key Features

• Oil-resistant rubber construction resists degradation from petroleum and compressor oil exposure
• 200 psi working pressure rating suitable for standard pneumatic tool service
• Wide service temperature range: -20 to 190 degrees F
• 3/8 inch inside diameter with 0.688 inch outside diameter
• Cut-to-length availability with 25-foot minimum cut from a 500-foot coil
• No end connections included — field-install fittings as required

Compatibility

Designed as a cut-to-length compressed air hose for general pneumatic service applications where oil resistance and a 3/8 inch ID are required. No specific equipment compatibility data was provided.

Installation Notes

Installation is typically performed by licensed HVAC technicians, plumbers, pipefitters, or qualified shop mechanics. Depressurize the air system completely before cutting or fitting the hose. Use appropriately rated barb or swage fittings and clamps compatible with rubber hose and the 3/8 inch ID dimension. Verify that all fittings and assemblies are rated to at least the system working pressure before returning the line to service.