Colonial Bronze 70064 Round Lip Edge Pull Satin Brass

Product Description

The COLONIAL BRONZE 70064 is a round lip edge pull from the 700 Series, designed for cabinet and architectural hardware applications. It features a 6-inch center-to-center spacing and a satin brass finish, making it a practical choice for cabinetry installations in both residential and light commercial settings. At 0.3 pounds and measuring 6 inches in length, 1 inch in width, and 1.2 inches in height, this pull fits standard cabinet door and drawer configurations. It is sold individually and suited for finish carpenters, cabinetmakers, and general contractors handling millwork and casework.

This edge pull is appropriate for use on cabinet doors and drawers where a low-profile, round lip design is required. The satin brass finish provides a consistent, brushed appearance that works with traditional and transitional cabinet styles. It is a single-unit item, so order quantities should match the number of pulls needed for the project. Typical applications include kitchen cabinetry, bathroom vanities, built-ins, and furniture casework.

Key Features

• 6-inch center-to-center spacing for standard cabinet hardware layout
• Round lip edge pull profile for low-profile, flush-mount door and drawer use
• Satin brass finish for a brushed, non-reflective appearance
• Compact form factor: 6 inches long, 1 inch wide, 1.2 inches tall
• Lightweight at 0.3 pounds, suitable for frequent-use cabinet applications
• Sold individually, allowing precise quantity ordering per project

Compatibility

Designed as an OEM-style replacement or new-installation pull for standard residential and commercial cabinetry with 6-inch center-to-center hole spacing.

Installation Notes

Installation is typically performed by a finish carpenter or cabinetmaker using a drill, appropriate bit, and a screwdriver or driver bit. Power down any adjacent electrical components before drilling into cabinetry near outlets or low-voltage wiring. Verify the center-to-center measurement against the cabinet door or drawer face before drilling to avoid misalignment. Fasteners are not always included and should be confirmed at time of order.