Chicago Pneumatic T025097 Inline Air Screwdriver 1800 Rpm

Product Description

The CHICAGO PNEUMATIC T025097 is an inline-handle pneumatic screwdriver designed for production assembly, maintenance, and repair environments where controlled fastening torque is required. Powered by compressed air through a 1/4 NPTF inlet, it runs at 1,800 RPM with a cushion clutch that limits output torque to a range of 31 to 44 inch-pounds, helping prevent overdriving and fastener damage. The 1/4 inch bit holder accepts standard hex bits. At 2.5 pounds, the tool is light enough for extended use on the line. Licensed HVAC, refrigeration, and electrical technicians as well as industrial maintenance trades use this class of screwdriver for panel assembly, equipment installation, and component replacement tasks that call for repeatable, low-torque fastening.

The T025097 suits light-duty production and service work where an inline grip profile is preferred over pistol or right-angle configurations. The inline handle allows the operator to apply straight-line force along the fastener axis, which is useful in tight bays, equipment cabinets, and control panel enclosures. At 4 CFM air consumption, it operates efficiently on most shop compressor setups running 1/4 inch supply lines. This tool is appropriate for residential and light commercial service applications as well as bench assembly operations.

Key Features

• Inline handle profile for straight-line fastening in confined spaces
• Cushion clutch limits torque to 31 to 44 inch-pounds (3.50 to 5.00 N/m) to protect fasteners and components
• 1,800 RPM no-load speed for efficient driving without over-spinning
• 1/4 inch hex bit holder accepts widely available standard bits
• 1/4 NPTF air inlet compatible with standard shop supply lines
• Lightweight at 2.5 pounds for reduced fatigue during extended use

Compatibility

Designed as a direct-use pneumatic screwdriver for any application requiring a 1/4 inch hex bit holder, cushion-clutch torque control, and a 1/4 NPTF compressed air supply.

Installation Notes

Connect to a clean, dry compressed air supply using a 1/4 inch NPTF fitting and an inline oiler or airline lubricator to extend tool life. Verify supply pressure matches the tool manufacturer specifications before operation. Disconnect the air supply before changing bits or performing any service on the tool. Follow applicable workplace safety standards and OSHA requirements for pneumatic tool use.