Charlotte Pipe Pvc 02108 1000HA Pvc Reducer Bushing 1-1/4x1

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 02108 1000HA is a white PVC reducer bushing designed to step down pipe size from 1-1/4 inches to 1 inch in pressure-rated PVC piping systems. It connects via a spigot inlet and a female-threaded outlet, allowing a standard male-threaded fitting or pipe end to mate securely on the smaller side. The bushing meets ASTM D 2466 requirements, confirming compliance with dimensional and pressure standards for Schedule 40 PVC fittings. Plumbers and irrigation contractors install this part where a pipe run must transition to a smaller diameter without adding extra couplings or adapters.

This reducer bushing is used in residential and commercial sprinkler and irrigation systems as well as general plumbing drain, waste, and cold-water supply lines where PVC Schedule 40 fittings are appropriate. The spigot end inserts directly into a socket fitting of the larger size, while the female-threaded end accepts a 1-inch male-threaded pipe or fitting. Each package contains 25 pieces, making it a practical supply for contractors running multiple zones or handling service calls requiring size reductions at valves, manifolds, or lateral lines.

Key Features

• Reduces pipe size from 1-1/4 inches to 1 inch in a single fitting
• Spigot x female-thread connection eliminates the need for additional adapters
• Meets ASTM D 2466 dimensional and pressure requirements for Schedule 40 PVC fittings
• White PVC construction suited for above-grade and in-ground irrigation applications
• Sold in a 25-piece package, supporting bulk installation and contractor restocking

Compatibility

Designed as an OEM-style Schedule 40 PVC fitting for use in sprinkler and irrigation systems as well as general cold-water PVC piping where ASTM D 2466 fittings are specified.

Installation Notes

Installation is typically performed by a licensed plumber or irrigation contractor following local plumbing codes and applicable ASTM standards. Turn off system water pressure completely before cutting into any existing line. Clean and deburr pipe ends, apply a suitable PVC primer and solvent cement to the spigot connection, and hand-tighten threaded connections with thread-seal tape before using strap wrenches. Do not over-torque threaded PVC connections, as this can crack the fitting body.