Charlotte Pipe Pvc 02100 3400HA 3/4x1/2 Pvc Reducing Coupling

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 02100 3400HA is a white PVC reducing coupling in a 3/4 inch by 1/2 inch slip-by-slip configuration. It is used to step pipe diameter up or down within a PVC piping system, making it a standard fitting for transitions between differently sized runs. The slip-on ends accept solvent-weld connections, which provide a permanent, pressure-rated joint. This fitting meets the requirements of ASTM D 2466, the widely referenced standard for PVC Schedule 40 socket-type fittings. Licensed plumbers, irrigation contractors, and qualified sprinkler technicians are the typical installers.

This reducing coupling is designed for use in sprinkler and irrigation systems where pipe size transitions are required between supply mains and lateral lines. Its Schedule 40 PVC construction handles the operating pressures common in residential and light commercial irrigation layouts. The fitting ships in a package quantity of 50 units, making it practical for jobsite stock or system installations requiring multiple reduction points across a zone layout.

Key Features

• 3/4 inch to 1/2 inch reduction in a single slip-by-slip fitting
• Solvent-weld slip connections on both ends for permanent, leak-resistant joints
• Meets ASTM D 2466 requirements for Schedule 40 PVC socket fittings
• White PVC construction suitable for irrigation and sprinkler piping
• Packaged in quantities of 50 units per pack for bulk installation use

Compatibility

Designed as an OEM-style replacement and standard-stock fitting for PVC Schedule 40 piping systems used in sprinkler and irrigation applications requiring a 3/4 inch to 1/2 inch slip reduction.

Installation Notes

Installation is performed by licensed plumbers or qualified irrigation technicians following local plumbing codes and applicable ASTM standards. Before cutting into any pressurized line, shut off the water supply and relieve system pressure completely. Solvent-weld connections require the use of a compatible PVC primer and cement applied per the cement manufacturer's instructions and allowed to cure before pressurizing. Do not apply heat or mechanical force to seat the fitting.