Charlotte Pipe Abs 00104R 0600HA 1-1/2 in Trap Adapter

Product Description

The Charlotte Pipe Foundry ABS 00104R 0600HA is a 1-1/2 inch ABS DWV trap adapter configured with a hub inlet and a slip jamnut outlet. It is used to connect ABS drain pipe to tubular trap assemblies at the wall or floor. The hub end accepts standard ABS pipe with solvent cement, while the slip jamnut secures the trap arm without threading. This fitting is rated for non-pressure drain, waste, and vent applications only. Licensed plumbers and experienced piping installers handle this component during rough-in and finish plumbing work. The black ABS material provides adequate service life in typical residential drain, waste, and vent systems.

This trap adapter is suited for residential and light commercial plumbing installations where ABS DWV pipe transitions to a tubular P-trap at a sink, lavatory, or similar fixture. The hub x slip configuration allows for straightforward connection at wall stub-outs or floor outlets without specialized tools. It is not rated for pressure service and should not be used in pressurized water supply lines. This fitting ships in a package quantity of 50 units, making it appropriate for plumbing contractors stocking out multi-unit residential or commercial projects.

Key Features

• 1-1/2 inch hub x slip jamnut configuration for connecting ABS pipe to tubular traps
• Designed for non-pressure drain, waste, and vent service only
• Hub end accepts ABS pipe with standard solvent cement joint
• Slip jamnut outlet allows secure, adjustable connection to trap arm
• Black ABS material suitable for DWV applications
• Available in a package quantity of 50 units for contractor supply

Compatibility

Designed as an OEM-style DWV fitting for use with standard 1-1/2 inch ABS drain, waste, and vent pipe systems in non-pressure residential and light commercial applications.

Installation Notes

Installation is performed by licensed plumbers in accordance with the International Plumbing Code and applicable local codes. Solvent-cement the hub end to the ABS stub-out pipe following the manufacturer cement instructions and allow full cure time before placing the system into service. Hand-tighten the slip jamnut onto the trap arm and confirm alignment before final snugging — do not overtighten, as the jamnut and trap arm are tubular fittings not rated for high torque. This fitting is not approved for use in pressure water supply lines under any circumstances.