C2G CG00749 Cat6a Snagless Patch Cable 10 Feet Aqua

Product Description

The C2G CG00749 is a 10-foot Cat6a snagless unshielded network patch cable finished in aqua. Cat6a cabling supports 10 Gigabit Ethernet at frequencies up to 500 MHz, making it a step up from standard Cat6 in high-throughput network environments. The snagless boot design protects the RJ45 latch during installation and cable management, reducing the risk of accidental disconnection. This cable is sold as a single unit and is suited for structured cabling work, rack patching, and device-to-switch runs installed by network technicians and low-voltage cabling contractors.

The CG00749 is intended for use in horizontal runs, patch panel connections, and direct device links in both residential and light commercial network installations. Its 10-foot length suits mid-distance connections between wall jacks, patch panels, switches, routers, and end devices. The aqua jacket aids color-coded cable management in dense rack environments where quick visual identification of cable type or network segment is standard practice.

Key Features

• Cat6a specification supports 10 Gigabit Ethernet and 500 MHz bandwidth
• Snagless boot protects RJ45 latch during routing and repeated handling
• Unshielded (UTP) construction for straightforward installation without grounding requirements
• Aqua jacket for color-coded cable management in structured cabling environments
• 10-foot length suits a wide range of patch panel and device connection scenarios

Compatibility

Designed as a standard Cat6a patch cable compatible with RJ45 ports on network switches, routers, patch panels, and network interface cards that accept Cat6a or backward-compatible Cat6 and Cat5e connections.

Installation Notes

Low-voltage cabling contractors and network technicians typically install structured cabling of this type. Route cables away from high-voltage conduit and sources of electromagnetic interference per NEC Article 800 guidelines for communications wiring. Avoid sharp bends that exceed the cable minimum bend radius, and do not cinch cable ties so tightly that the jacket deforms. No special tools beyond a patch panel punch-down tool or standard RJ45 crimp tool are required for termination work associated with this cable type.