Bsc Preferred XOP30-AER Rust Preventative Enamel Spray 12 Oz

Product Description

The BSC PREFERRED XOP30-AER is a 12-ounce aerosol rust preventative enamel spray paint formulated for direct-to-metal application. It delivers a flat white finish on both interior and exterior surfaces without requiring a separate primer coat, functioning as a paint and primer in one. The formula carries a maximum infrared reflectance (MIR) rating of 1.4, indicating compliance with low-VOC or air-quality standards applicable in regulated regions. Fleet maintenance crews, facility technicians, and trade professionals use this product to protect metal surfaces from rust and corrosion in a single-step process.

This spray enamel is suited for use on metal equipment, ductwork, structural steel, machinery, vehicles, and other ferrous or non-ferrous metal surfaces in both indoor and outdoor environments. The flat white finish makes it a practical choice for HVAC equipment casings, electrical enclosures, and general facility maintenance applications where a clean, low-sheen appearance is required. It is appropriate for residential, commercial, and light industrial settings.

Key Features

• Paint and primer in one — no separate primer coat required for direct-to-metal application
• Rust and corrosion preventative enamel formula
• Flat white finish suitable for interior and exterior surfaces
• 12-ounce aerosol spray can for controlled, even application
• MIR 1.4 rating for compliance with applicable air-quality regulations
• Suitable for fleet, facility, and light industrial maintenance use

Compatibility

Designed for direct application to bare or prepared metal surfaces including ferrous metals, structural steel, machinery housings, and equipment enclosures in interior and exterior environments.

Installation Notes

Surface preparation is critical — remove loose rust, grease, and contaminants before application. Shake the can thoroughly before spraying and apply in thin, even coats according to the product label directions. Use in well-ventilated areas and follow all applicable safety data sheet (SDS) guidelines for aerosol coatings. Allow adequate dry time between coats and before returning equipment to service.