Bsc Preferred HLT166 Hook and Loop Fastener Roll

Product Description

The BSC PREFERRED HLT166 is a hook and loop fastener roll designed for mounting and hanging applications across a wide range of work environments. The touch fastener closure system interlocks hundreds of hooks with hundreds of loops on contact, forming a secure mechanical bond. Releasing the bond is simple: pulling the two sides apart straightens the hooks and disengages them from the loops without damage. A rubber-based, pressure-sensitive adhesive backs the tape, making it suitable for both high and low temperature environments. The roll is weather-resistant, making it a practical choice for indoor and outdoor installations.

This fastener roll is commonly used to mount signs, posters, displays, tools, and lightweight equipment. It is suited for commercial and residential applications where a reusable, adhesive-backed mounting solution is needed without drilling or permanent hardware. Note that hook and loop components are sold separately. The HLT166 is equivalent to part number S-17138 and is sold by the roll, making it well-suited for repeated use across multiple mounting points on a job site or in a facility.

Key Features

• Touch fastener closure system: hooks interlock with loops on contact for a secure, repeatable bond
• Rubber-based, pressure-sensitive adhesive rated for high and low temperature environments
• Weather-resistant construction suitable for indoor and outdoor use
• Releases cleanly without damage when sides are pulled apart
• Sold by the roll; hook and loop sides sold separately
• Equivalent replacement for part number S-17138

Compatibility

Designed as a direct equivalent to part number S-17138. Suitable for general-purpose hook and loop mounting applications on clean, dry surfaces in commercial and residential settings.

Installation Notes

Clean and dry the mounting surface thoroughly before applying the adhesive-backed tape to ensure proper adhesion. Apply firm pressure across the full length of the tape for several seconds after placement. Hook and loop sides must be purchased separately and aligned carefully before pressing together. Allow adequate cure time for the adhesive before loading the fastener with weight.