Bsc Preferred G13043 Tyvek Id Tags Pre-wired 1000/case

Product Description

The BSC PREFERRED G13043 is a case of 1000 pre-wired Tyvek identification tags built for demanding job-site and facility environments. Manufactured from spunbonded olefin, these tags resist tearing, moisture, chemicals, and mildew - holding up where paper tags fail. Each tag comes fitted with a 3/16 inch metal eyelet and is pre-wired with 12 inches of 26-gauge double wire, ready to attach without additional prep. HVAC, plumbing, electrical, and mechanical contractors use these tags for equipment labeling, pipe and valve identification, lockout-tagout staging, and general asset marking in wet or corrosive conditions.

These Tyvek tags are suited for both residential and commercial applications where durable, long-lasting identification is required. Typical install scenarios include labeling refrigerant lines, breaker panels, valves, conduit runs, and mechanical equipment during installation or service calls. The pre-wired format saves time in the field. Additional wire is available separately under stock number G2500. Each case contains 1000 tags, making it practical for stocking a service van or supply room. This product is equivalent to part number S-2022PW.

Key Features

• Spunbonded olefin construction resists tearing and moisture in wet or outdoor environments
• Chemical and mildew resistant material maintains legibility over time
• 3/16 inch metal eyelet provides a secure, reinforced attachment point
• Pre-wired with 12 inches of 26-gauge double wire - no separate wiring step required
• 1000 tags per case for high-volume stocking and field use
• Compatible with additional wire stock number G2500 for extended reach applications

Compatibility

General-purpose identification tags suitable for use across HVAC, plumbing, electrical, and mechanical trades wherever durable equipment or component labeling is required. Equivalent to part number S-2022PW.

Installation Notes

No special tools are required to attach these tags - the pre-wired eyelet loops directly onto pipes, valves, handles, or equipment frames. When used in lockout-tagout procedures, verify compliance with applicable OSHA 29 CFR 1910.147 control of hazardous energy requirements. Write identification information before attaching in high-moisture environments to ensure legibility. Store unused tags in a dry location to maintain wire integrity.