Bramec 19115 Master Flash Pipe Flashing Epdm 5-9 in

Product Description

The BRAMEC 19115 is an EPDM rubber pipe flashing designed to create a watertight seal around roof penetrations for pipes ranging from 5 inches to 9 inches in diameter. This type of flashing is used to prevent water intrusion at the point where a pipe exits through a roof deck. EPDM construction provides flexibility and long-term resistance to UV exposure, ozone, and weathering. It is typically installed by HVAC technicians, plumbers, or roofers during new construction or service calls that involve rooftop pipe penetrations.

The BRAMEC 19115 Master Flash pipe flashing is suited for residential and light commercial applications where B-vent, PVC, CPVC, or other round pipe runs penetrate a sloped or flat roof surface. It is commonly installed over flue vents, plumbing stacks, and conduit runs. The flexible EPDM base conforms to roof pitch and surface texture, reducing the need for additional sealants in typical installations.

Key Features

• Fits pipe diameters from 5 inches to 9 inches
• EPDM rubber construction resists UV, ozone, and weathering
• Flexible base conforms to varied roof pitches and surface profiles
• Creates a watertight seal at roof penetrations without additional sealants in standard conditions
• Suitable for B-vent, plumbing stack, and conduit applications

Compatibility

Designed for use with round pipe penetrations between 5 inches and 9 inches in outer diameter on residential and light commercial roofing applications.

Installation Notes

Installation is typically performed by a licensed plumber, HVAC technician, or roofer. Ensure the pipe is fully supported and positioned before sliding the flashing over the pipe and seating the base firmly against the roof surface. Follow local building codes and manufacturer guidance regarding fastening and any supplemental sealant requirements. Do not install over damaged or deteriorated roof decking without completing necessary repairs first.