Boshart pvca-20 Pvc Adapter 2 Inch Mpt X Insert

Product Description

The BOSHART pvca-20 is a 2-inch MPT x Insert PVC adapter fitting designed for irrigation and fluid distribution systems. It transitions from a male pipe thread connection to an insert-style barb connection, allowing technicians to join threaded pipe assemblies with poly or flexible tubing. The fitting is molded from rigid PVC, which provides strong chemical resistance and dimensional stability under normal operating conditions. Licensed plumbers and irrigation contractors typically install this fitting in both above-ground and surface-level runs where sun exposure and freeze-thaw cycles are a concern.

This adapter is suited for residential, commercial, and industrial irrigation applications. Because PVC is not degraded by ultraviolet exposure, the pvca-20 can be installed in direct sunlight without UV inhibitor concerns. In applications where lines are not buried below the frost line, the rigidity of PVC is an advantage: if residual water in the line freezes, the ice is forced out lengthwise rather than expanding the fitting radially, helping maintain a positive seal. It is a practical choice for surface-run drip systems, lateral lines, and manifold assemblies.

Key Features

• 2-inch MPT x Insert connection type for threading into female-threaded fittings and coupling to poly tubing
• Rigid PVC construction provides chemical resistance and structural stability
• UV-resistant material allows direct outdoor and sun-exposed installation
• Freeze-resistant geometry directs ice expansion lengthwise to protect seal integrity
• Suitable for residential, commercial, and industrial irrigation service

Compatibility

Designed as an OEM-style replacement and general-use fitting for PVC irrigation and fluid distribution systems using 2-inch MPT threaded connections with insert-style poly tubing.

Installation Notes

Installation is typically performed by licensed plumbers or qualified irrigation technicians following applicable plumbing and irrigation codes. Shut off the water supply and relieve system pressure before removing or installing any fitting. Apply thread sealant tape to the male pipe threads before engagement, and hand-tighten before using a strap wrench to avoid cracking the PVC body from over-torquing. Ensure the insert barb end is fully seated into the poly tubing and secured with an appropriate clamp or insert ring per system design requirements.

Technical Specifications

• Size: 2 inches
• Connection Type: MPT x Insert
• Primary Material: PVC
• Fitting Type: Adapter
• Industry Number: 1436-020

Standard Information

• Brand: BOSHART
• Manufacturer Part Number: pvca-20