Bk Mueller 560-100HC Galvanized Pipe Nipple 1/8 in 10 in Sch 40

Product Description

The BK MUELLER 560-100HC is a galvanized steel pipe nipple designed for use in threaded piping systems where corrosion resistance and durability are required. Manufactured to Schedule 40 wall thickness, this nipple measures 1/8 inch in pipe size and 10 inches in length, with NPT threads on both ends. It is used to connect, extend, or offset sections of threaded pipe in gas, water, and general fluid distribution lines. Licensed plumbers and pipefitters are the typical installers. The galvanized coating provides added protection against rust and oxidation in wet or exposed environments.

This nipple is suited for residential and light commercial plumbing, gas distribution, and mechanical piping applications. It fits into standard 1/8-inch NPT threaded fittings, valves, and manifolds. The 10-inch length makes it appropriate for bridging moderate gaps between fittings without additional couplings. It is commonly installed in boiler rooms, utility lines, and equipment connections where a Schedule 40 rated component is specified.

Key Features

• Schedule 40 wall thickness for standard-duty pressure applications
• Galvanized steel construction for corrosion resistance in wet and outdoor environments
• NPT threads on both ends for compatibility with standard threaded fittings
• 1/8-inch pipe size with 10-inch usable length
• Single-piece construction with no joints or seams between threads

Compatibility

Designed as an OEM-style replacement or standard fitting for use with 1/8-inch NPT threaded pipe fittings, valves, and couplings in Schedule 40 piping systems.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC or IFGC requirements depending on the service fluid. Shut off water or gas supply and depressurize the line before removing or installing any threaded nipple. Apply thread sealant or PTFE tape to the male threads before assembly and tighten with a pipe wrench to a leak-free fit without over-torquing. Inspect threads for damage before installation and do not use a nipple with crossed or stripped threads.