Belden Inc. FP4LULU08M5R6XA OM4 Fiber Patch Cable

Product Description

The BELDEN INC. FP4LULU08M5R6XA is an OM4 multimode fiber optic patch cable configured with LC duplex connectors on both ends. It ships as an 8-fiber assembly in a 5-meter length, making it suitable for high-density structured cabling environments where short-run, high-bandwidth interconnects are required. The OM4 fiber grade supports 10 Gigabit and 40/100 Gigabit Ethernet applications over multimode infrastructure. Licensed electricians, low-voltage cabling technicians, and data center installers are the primary trades that specify and terminate this type of assembly in rack-to-rack and equipment-to-patch-panel runs.

This patch cable is intended for use in commercial and enterprise data center, telecommunications room, and structured cabling applications. The LC duplex to LC duplex configuration matches commonly deployed active equipment ports and fiber distribution panels. The 5-meter length suits in-rack or short cross-connect runs without excess slack management. The 8-fiber count accommodates parallel or multi-lane optical interconnects common in modern switching and storage infrastructure.

Key Features

• OM4 multimode fiber supports 10GbE, 40GbE, and 100GbE transmission
• LC duplex connectors on both ends for compatibility with high-density panels and transceivers
• 8-fiber assembly in a single cable for parallel or multi-lane optical runs
• 5-meter length suited for rack-to-rack and short cross-connect installations
• Factory-terminated and tested assembly reduces field termination labor

Compatibility

Designed as an OEM-style replacement or new-installation fiber patch assembly for OM4 multimode structured cabling systems using LC duplex connector interfaces.

Installation Notes

Installation should be performed by a qualified low-voltage cabling technician or licensed electrician familiar with TIA-568 structured cabling standards. Inspect connector ferrules for contamination before mating and clean with appropriate fiber optic cleaning tools prior to insertion. Do not exceed the minimum bend radius of the cable during routing, as exceeding this limit can cause signal loss or physical damage to the fiber. Disconnect all associated active equipment from power before making or breaking fiber connections to protect optical transceivers.