Baso H91RG-2CREVB Automatic Gas Valve 24V 3/4 Npt

Product Description

The BASO H91RG-2CREVB is an automatic single shut-off solenoid gas valve designed for automatic gas control in heating equipment. Operating on 24 volts, it uses an electromechanical solenoid to open and close the gas flow path in response to a low-voltage control signal from a thermostat or ignition control board. The valve features a 3/4 inch NPT connection, making it compatible with standard gas piping configurations found in residential and light commercial heating systems. It is installed by licensed HVAC technicians or gas fitters during equipment servicing or component replacement.

This valve is suited for use in gas-fired appliances such as furnaces, boilers, and similar heating equipment that require automatic shut-off control at the appliance gas inlet. The 24-volt solenoid design integrates with standard low-voltage control circuits common in residential heating systems. The single shut-off configuration provides one stage of automatic gas flow control, appropriate for systems that do not require staged or modulating gas valve operation.

Key Features

• Automatic single shut-off solenoid operation for reliable gas flow control
• 24-volt coil voltage compatible with standard low-voltage heating control circuits
• 3/4 inch NPT inlet and outlet connections for standard gas piping
• Assembled unit ready for direct installation as a replacement component
• Lightweight at 1 pound for straightforward handling during service calls

Compatibility

Designed as an OEM-style replacement automatic shut-off solenoid gas valve for gas-fired heating appliances using 24-volt control circuits and 3/4 inch NPT gas connections.

Installation Notes

Installation must be performed by a licensed HVAC technician or qualified gas fitter in accordance with applicable local codes and the IFGC. Shut off the main gas supply and disconnect electrical power to the appliance before removing the existing valve. Verify inlet and outlet flow direction markings on the valve body before making pipe connections, and leak-test all joints with an approved gas leak detection solution after restoring gas supply. Do not apply excessive torque to the NPT fittings in a way that stresses the valve body.