Au-ve-co Products 19801 Push Mount Blind Rivet

Product Description

The AU-VE-CO PRODUCTS 19801 is a push mount blind rivet designed for tool-free, snap-in fastening in panel and trim assembly applications. The dome head profile seats flush against the workpiece surface, while the all-nylon body and nylon mandrel make this rivet well suited for environments where corrosion resistance or electrical non-conductivity is a priority. With a maximum grip of 5.00 millimeters and a maximum hole diameter of 6.00 millimeters, it fits a defined range of panel thicknesses and punched or drilled hole sizes. Installation requires no rivet gun - the fastener pushes into the hole and locks in place. This rivet is commonly installed by HVAC technicians, electricians, and equipment assembly technicians working with sheet-metal panels, plastic enclosures, and light-gauge assemblies.

This rivet is used in residential and light commercial applications wherever a clean, removable, or semi-permanent panel fastener is needed. Typical scenarios include securing access panels on HVAC equipment, attaching wire management clips, and fastening trim pieces on electrical enclosures. The push mount design speeds up repetitive assembly tasks where tool access is limited or a rivet gun is impractical.

Key Features

• Push mount installation requires no rivet gun or specialized tooling
• All-nylon body and mandrel resist corrosion and provide electrical non-conductivity
• Dome head design provides a clean finished appearance at the panel surface
• Maximum grip of 5.00 millimeters suits a range of panel thicknesses
• Maximum hole diameter of 6.00 millimeters for consistent, repeatable fitment

Compatibility

Designed as an OEM-style push mount fastener for use in panel, trim, and enclosure assemblies where a maximum hole diameter of 6.00 millimeters and a maximum grip of 5.00 millimeters are required.

Installation Notes

Installation is performed by hand - align the rivet with the prepared hole and apply firm, even pressure until the fastener seats and locks. Ensure the hole diameter does not exceed 6.00 millimeters for proper retention. Power down any electrical equipment before accessing enclosures or panels. Removal typically requires a small flathead tool to release the locking tab without damaging the panel.