Atg 19-D475/L Cut-resistant Gloves Size L Ansi A4

Product Description

The ATG 19-D475/L is a paired cut-resistant work glove designed for trade and industrial applications where hand protection and grip performance are required simultaneously. Built on a 13-gauge seamless Dyneema liner, the glove meets ANSI/ISEA Cut Resistance Level A4 and ANSI/ISEA Abrasion Resistance Level 4. The palm, fingers, and knuckles are coated with micro-foam nitrile, which provides a secure MicroFoam grip surface compatible with light oils. A knit wrist cuff helps keep dirt and debris out during extended work. At size Large, this glove fits most adult male hands and medium women's hands. The overall length is 9.1 inches.

These gloves are suited for electricians, plumbers, HVAC technicians, pipefitters, and general trade workers who handle sheet metal, conduit, pipe, and other materials with moderate to high cut hazard. The nitrile microfoam coating supports dexterity tasks such as sorting hardware, handling fittings, and pulling wire without removing the glove. The MicroFoam grip surface maintains tactile feedback even in light-oil or slightly wet conditions. The seamless Dyneema lining reduces interior friction and improves all-day wearability on the job site.

Key Features

• ANSI/ISEA Cut Resistance Level A4 and Abrasion Resistance Level 4 for reliable hand protection
• Micro-foam nitrile coating covers palm, fingers, and knuckles for broad grip coverage
• MicroFoam grip surface compatible with light oils for wet or oily-condition work
• 13-gauge seamless Dyneema liner reduces interior irritation during extended wear
• EN 388 Rating 4443DX meets both ANSI and EN 388 standards
• Knit wrist cuff seals out debris and provides a secure, comfortable fit

Compatibility

Designed as an OEM-style paired glove set for size Large users across general trade, construction, and industrial service applications where ANSI Cut A4 protection is required.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that would compromise cut protection. Replace immediately if the liner or coating is damaged. When working near energized electrical components, confirm glove ratings meet applicable NFPA 70E or OSHA requirements, as these gloves are not rated for electrical arc or high-voltage protection. Store away from sharp edges and direct sunlight when not in use.