Associated Spring Raymond 106-832 Die Spring 8 in

Product Description

The ASSOCIATED SPRING RAYMOND 106-832 is a heavy-duty die spring engineered for high-load industrial tooling and stamping applications. Built from chromium alloy steel with a trapezoidal wire cross-section, it delivers a maximum deflection load of 2,000 pounds and a spring rate of 1,116 pounds per inch. The free length measures 8 inches, with a hole diameter of 2 inches and a rod diameter of 1 inch. The green color coding identifies this as a heavy-load class spring per standard die spring classification systems. Licensed HVAC, plumbing, and mechanical trades as well as tooling maintenance professionals install and service these components in press tooling, punch dies, and related machinery.

This die spring is suited for use in industrial stamping presses, punch and die assemblies, and other high-cycle tooling setups where consistent load and deflection performance is required. The 2 inches of maximum deflection allows for controlled compression travel within a die set. Its chromium alloy steel construction supports repeated compression cycles under heavy load conditions common in production manufacturing environments.

Key Features

• Maximum deflection load of 2,000 pounds for heavy-duty tooling applications
• Spring rate of 1,116 pounds per inch for predictable load response
• Trapezoidal wire cross-section maximizes wire volume and load capacity within the coil
• Chromium alloy steel construction for strength and fatigue resistance under repeated cycling
• Green color coding denotes heavy-load classification for quick identification during tooling setup
• Manufactured under ISO 9001:2008 and ISO/TS 16949:2009 certified quality systems

Compatibility

Designed for use in standard die sets requiring a 2 inches hole diameter, 1 inch rod diameter, and 8 inches free length heavy-load die spring. Verify press stroke, die set clearances, and required spring rate before installation.

Installation Notes

Die springs are installed by qualified tooling technicians or mechanical maintenance personnel. De-energize and lock out all press equipment before removing or installing die springs. Ensure the spring is properly seated on the rod and within the pocket to prevent lateral movement under load. Do not compress beyond the rated maximum deflection of 2 inches, as over-compression causes permanent set and premature failure.