Apollo Valves 670750619519 2-piece Ball Valve 3/4 in Solder

Product Description

The APOLLO VALVES 670750619519 is a 2-piece, 3/4-inch solder-end ball valve from the 70LF-240 series, built for plumbing and hydronic heating systems where lead free construction is required. The body is lead free bronze with a 316 stainless steel ball and stem, and RPTFE seat and softgoods. It carries a cold water pressure rating of 600 psi and a temperature rating of 450 degrees F, making it suitable for a wide range of residential and commercial water service applications. A lever-operated actuator provides direct quarter-turn shutoff. Licensed plumbers and mechanical contractors are the typical installers for this valve.

The 70LF-240 series is designed for potable water, plumbing distribution, and heating systems where lead free compliance is mandated by code, including applications subject to the Reduction of Lead in Drinking Water Act. The standard port configuration and solder-end connections are well suited for copper pipe systems commonly found in residential and light commercial construction. Inlet to outlet length measures 3.87 inches and top to inlet center measures 2.12 inches, allowing for straightforward layout planning in tight mechanical spaces.

Key Features

• Lead free bronze body meets lead free code requirements for potable water service
• 316 stainless steel ball and stem for corrosion resistance in water and heating applications
• RPTFE seat and softgoods for chemical resistance and long service life
• 600 psi CWP and 450 degrees F temperature rating for demanding system conditions
• Quarter-turn lever actuator for fast, positive shutoff
• Solder-end connections compatible with standard copper pipe installations
• Domestically produced

Compatibility

Designed as a lead free OEM-style replacement or new-installation ball valve for 3/4-inch copper pipe plumbing, potable water distribution, and hydronic heating systems requiring solder-end connections and lead free bronze construction.

Installation Notes

Installation is typically performed by a licensed plumber in accordance with the International Plumbing Code and applicable local amendments. Shut off the water supply and depressurize the line before soldering to avoid damaging the RPTFE seat and softgoods — heat from soldering should be applied to the fitting ends with the valve in the open position to allow heat dissipation. Allow the joint to cool completely before restoring pressure. Verify the system pressure does not exceed the rated 600 psi CWP after installation.