Apex TW-2 Tri-wing Power Screwdriver Bit Size 2

Product Description

The APEX TW-2 is a Tri-Wing specialty power screwdriver bit designed for use with power screwdrivers and impact-rated hex drive tools. It features a 1/4 inch hex drive shank and an overall length of 1.25 inches. The No. 2 Tri-Wing point engages tri-wing fastener recesses commonly found in consumer electronics, aerospace assemblies, and specialized equipment where standard Phillips or Torx fasteners are not used. Electricians, electronics technicians, and field service professionals install and remove these fasteners during panel work, equipment servicing, or component replacement tasks.

This bit is suited for bench-top and field service applications where tri-wing fasteners are specified. It fits standard 1/4 inch hex quick-change bit holders and power screwdriver chucks, making it compatible with the cordless and corded power tools most technicians already carry. It ships as a single piece, appropriate for targeted specialty use rather than bulk kit replenishment.

Key Features

• No. 2 Tri-Wing specialty point engages tri-wing fastener recesses without cam-out
• 1/4 inch hex drive fits standard quick-change bit holders and power screwdriver chucks
• 1.25 inch overall length suitable for direct-drive and short-reach applications
• Single-piece packaging for individual replacement or kit supplementing
• Compatible with both corded and cordless power screwdrivers equipped with 1/4 inch hex chucks

Compatibility

Designed for use with any power screwdriver or quick-change bit holder accepting a standard 1/4 inch hex drive bit, when a No. 2 Tri-Wing fastener drive is required.

Installation Notes

Seat the 1/4 inch hex shank fully into the bit holder or chuck before operation to ensure positive engagement. Set the clutch or torque setting on the power screwdriver to an appropriate level for the fastener and material to avoid overdriving. Inspect the bit tip for wear or deformation before each use, as a damaged tri-wing tip can strip specialty fasteners that are difficult to replace. No special tools beyond a standard 1/4 inch hex chuck driver are required for installation of the bit itself.