Ansell 11541110 Cut-resistant Gloves A4 2XL

Product Description

The ANSELL 11541110 is a cut-resistant work glove rated ANSI/ISEA Cut Level A4, designed for industrial and trade applications where hand protection against sharp edges and abrasion is required. The glove features an 18-gauge shell constructed from Kevlar, nylon, spandex, and stainless steel, delivering a balance of cut resistance and dexterity. A foam nitrile coating covers the palm and fingertips, providing reliable grip on both dry and lightly oily surfaces. Rated ANSI/ISEA Abrasion Level 4 and EN 388 4X21D, the 11541110 is sized for 2X-Large hands and supplied as a pair. Licensed HVAC techs, electricians, plumbers, and other tradespeople handling sheet metal, conduit, or pipe commonly reach for this type of glove.

The 11541110 is suited for light to medium industrial tasks including sheet metal fabrication, mechanical assembly, glass handling, and general maintenance work. The seamless lining and knit cuff construction reduce hand fatigue during extended wear. The foam grip surface aids in handling components in low-moisture environments. The static dissipative properties make it appropriate for use near sensitive electrical components. This glove meets ANSI, EN ISO 21420:2020, and EN407 X1XXXX standards and has been evaluated under the Ecovadis 2022 sustainability framework.

Key Features

• ANSI/ISEA Cut Level A4 and ANSI Abrasion Level 4 protection for demanding trade environments
• 18-gauge shell with Kevlar, nylon, spandex, and stainless steel construction
• Foam nitrile palm and fingertip coating for grip on dry and lightly oily surfaces
• Seamless lining for reduced hand fatigue during extended use
• Static dissipative construction suitable for use near electrical components
• Knit cuff with 2.5-inch cuff length for secure fit and debris exclusion

Compatibility

Designed as an OEM-style replacement or direct-purchase cut-resistant glove for 2X-Large hands in industrial, mechanical, and trade service applications.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating delamination that could compromise protection. Always power down or de-energize equipment and shut off fluid supply before beginning any service task, even when wearing protective gloves. Gloves do not replace lockout/tagout procedures required under OSHA and applicable electrical codes. Replace immediately if the shell or coating shows visible damage.