Anderson Metals Corp 750062-08 Brass Compression Full Union

Product Description

The ANDERSON METALS CORP 750062-08 is a 1/2 inch brass compression full union designed for making fully disconnectable, leak-resistant joints in water supply and fluid distribution systems. This fitting uses a compression-style connection that does not require soldering, making it well suited for tight spaces or retrofit work. The 750062-08 is lead free compliant and meets the requirements of Public Law 111-380, satisfying safe drinking water standards for potable water applications. Licensed plumbers and experienced pipe fitters are the typical installers for this fitting in both residential and light commercial environments.

This compression full union is used in applications where a straight inline connection must be fully removable for future service or replacement. Common install scenarios include under-sink water supply lines, fixture connections, and copper or compatible tubing runs where a union joint is required. The lead free compliance makes it appropriate for potable water systems subject to state and local safe drinking water regulations. It is sold in a package quantity of 5 units, making it practical for service vehicles and multi-job inventory.

Key Features

• Lead free compliant, meets Public Law 111-380 for potable water use
• Compression-style connection requires no soldering or open flame
• Full union design allows the joint to be fully disconnected and reconnected for service
• 1/2 inch bore size fits standard half-inch tubing runs
• Brass construction provides corrosion resistance in wet plumbing environments
• Sold in a package of 5 units

Compatibility

Designed as an OEM-style compression union fitting for 1/2 inch tubing in residential and light commercial potable water plumbing systems.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and IPC guidelines. Shut off and depressurize the water supply line before disassembling or installing any compression fitting. Ensure tubing ends are cut cleanly and deburred before seating the compression sleeve to achieve a proper seal. Do not overtighten compression nuts, as excessive force can deform the sleeve and cause leaks.