Anderson Metals 736113-0432 Brass Pipe Nipple 2 in Npt

Product Description

The ANDERSON METALS 736113-0432 is a close-pattern brass pipe nipple threaded on both ends, designed for joining threaded pipe sections in a wide range of plumbing and fluid-handling systems. Machined from red brass, this nipple measures 2 inches overall length and carries standard NPT threads on each end, providing a secure, leak-resistant connection. It is lead free, making it suitable for potable water applications where regulatory compliance is required. Plumbers and pipefitters install this type of fitting during new construction, repair work, and system extensions.

This nipple is used in residential and light commercial plumbing systems, HVAC hydronic lines, compressed air distribution, and general fluid-handling applications where a short threaded connector is needed between two female-threaded fittings or valves. Its red brass construction offers good corrosion resistance in both hot and cold water service, as well as compatibility with a broad range of compatible pipe materials and system fluids. The NPT thread form is the standard for North American pipe installations.

Key Features

• Lead-free red brass construction meets requirements for potable water service
• NPT threads on both ends for standard North American pipe connections
• 2-inch overall length suits close-coupled fitting configurations
• Corrosion-resistant material suited for hot and cold water, hydronic, and air service
• Threaded on both ends for straightforward installation between female-threaded components

Compatibility

Designed as a standard NPT-threaded pipe nipple for use with female NPT-threaded fittings, valves, and pipe couplings in residential and commercial plumbing and fluid-handling systems.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters. Shut off the water supply and depressurize the system before disassembling any threaded connections. Apply an appropriate thread sealant or PTFE tape to the NPT threads before assembly to ensure a leak-free joint. Tighten to hand-snug and then wrench-tight using pipe wrenches; avoid overtightening, which can crack brass fittings.