Ampco S-1099A Phillips Screwdriver Size 1 Non-sparking

Product Description

The AMPCO S-1099A is a Phillips screwdriver designed for use in environments where spark hazard is a concern. Built with a non-sparking construction, it is suited for work around flammable gases, vapors, and combustible materials - conditions common in HVAC mechanical rooms, gas utility service, and industrial maintenance. The driver accepts a No. 1 Phillips point and features a 3-inch round shank with a plastic handle. Tradespeople working in classified or hazardous-location environments rely on non-sparking hand tools as a standard safety practice alongside other hazard controls.

This screwdriver is appropriate for light fastener work requiring a No. 1 Phillips tip in settings where standard steel tools present an ignition risk. Typical applications include service work near gas-fired equipment, fuel handling areas, chemical processing facilities, and any site where a hot work permit or hazardous-atmosphere protocol is in force. It is equally useful as a general-purpose No. 1 Phillips driver for everyday electrical panel, control board, or terminal block fastener work.

Key Features

• Non-sparking construction for use in flammable or explosive atmospheres
• No. 1 Phillips point size for small-to-medium fasteners
• 3-inch blade length on a round shank
• Plastic handle for comfortable grip and electrical separation from shank
• Single-piece packaging - sold individually

Compatibility

Designed as a general-purpose No. 1 Phillips hand screwdriver for use wherever a non-sparking tool is required by site safety protocol or trade practice.

Installation Notes

Non-sparking hand tools are selected by the installing trade based on site hazard assessment and applicable safety codes - consult NFPA 70E, facility hot work procedures, or local authority having jurisdiction requirements before tool selection. Always power down electrical equipment and shut off gas or fuel supplies before beginning fastener work on live systems. Inspect the driver tip before each use and replace if the Phillips point shows rounding or damage that could cause cam-out.