Altronix Corp EBRIDGE100SPR Eoc Poe Plus Receiver

Product Description

The ALTRONIX CORP EBRIDGE100SPR is an Ethernet over Coax (EoC) PoE+ receiver designed to work in conjunction with the eBridge200WPM transmitter. It extends Power over Ethernet Plus (PoE+) signals over existing coaxial cable infrastructure, eliminating the need to run new Cat5e or Cat6 wiring. The unit falls into the media converter category and is sold as a single piece. It is typically installed by low-voltage security and network technicians during IP camera system upgrades or new installations where coax is already in place.

The EBRIDGE100SPR is suited for commercial and residential security installations where transitioning from analog to IP-based camera systems over legacy coax runs is required. It pairs specifically with the eBridge200WPM and is used in point-to-point coax-to-Ethernet conversion setups. Installers use this receiver at the camera end of the coax run to deliver both data and PoE+ power to connected IP devices without pulling new structured cabling.

Key Features

• Extends PoE+ power and Ethernet data over existing coaxial cable
• Designed to operate as the receive-side unit in an eBridge EoC system
• Eliminates the need for new Cat5e or Cat6 cable runs in retrofit projects
• Supports PoE+ (802.3at) capable devices at the far end
• Sold as a single unit for flexible deployment

Compatibility

Designed to operate as the EoC PoE+ receiver paired with the ALTRONIX CORP eBridge200WPM transmitter unit in a point-to-point coaxial media conversion system.

Installation Notes

Installation should be performed by a qualified low-voltage technician familiar with EoC media conversion systems and PoE+ device requirements. Power down connected devices before making coax or Ethernet connections. Ensure coaxial cable terminations are clean and properly seated to maintain signal integrity. Refer to the manufacturer data sheet and any applicable local low-voltage wiring codes before installation.