Altronix Corp EBRIDGE100RM Eoc Receiver Poe Poe+

Product Description

The ALTRONIX CORP EBRIDGE100RM is an Ethernet over Coax (EoC) receiver designed to extend network connectivity and pass Power over Ethernet (PoE) and PoE+ signals over existing coaxial cable infrastructure. This unit functions as a media converter, bridging coax runs to standard Ethernet while maintaining PoE and PoE+ power delivery to connected devices. It is sold as a single unit and is deployed by low-voltage network technicians and security installers who need to leverage existing coax cabling rather than re-pulling Cat5e or Cat6 wire.

The EBRIDGE100RM is suited for commercial and residential installations where coaxial cable is already in place, such as legacy CCTV infrastructure being upgraded to IP-based systems. It is installed at the remote end of a coax run to convert the signal back to standard RJ45 Ethernet, allowing IP cameras, access control readers, or other PoE-powered devices to connect without new structured cabling. This makes it a practical solution for retrofits and system upgrades where coax runs are intact and replacing cable is cost-prohibitive.

Key Features

• Passes PoE and PoE+ power over coaxial cable to remote devices
• Functions as an EoC receiver, converting coax signal back to standard Ethernet at the endpoint
• Enables reuse of existing coaxial cable infrastructure for IP network deployments
• Sold individually as a single unit for flexible deployment
• Classified as a media converter for structured low-voltage network applications

Compatibility

Designed as an EoC receiver media converter for use in IP camera, access control, and network extension applications where existing coaxial cable infrastructure is present. Verify pairing with a compatible ALTRONIX CORP EoC transmitter for proper system operation.

Installation Notes

Installation should be performed by a licensed low-voltage technician or qualified network installer familiar with structured cabling and PoE system requirements. Power down all connected PoE source equipment before connecting or disconnecting this unit. Follow local building codes and NEC low-voltage wiring guidelines when routing coaxial and Ethernet cabling. Do not exceed the PoE or PoE+ power budget of the source switch or injector powering the system.