Allpoints 34093.0001 Oval Reservoir Brew-thru Lid

Product Description

The ALLPOINTS 34093.0001 is a replacement oval reservoir brew-thru lid designed for Bunn-O-Matic commercial coffee brewing equipment. Made from plastic, this lid fits over the brew reservoir and allows brewed coffee to pass through directly into the decanter or airpot below. It replaces worn, cracked, or missing OEM-style lids that are a routine wear item in high-volume foodservice environments. At 0.5 pounds and roughly 13.5 inches in length by 10.5 inches in width, it is a straightforward drop-in replacement that requires no tools to install. Foodservice equipment technicians and commercial kitchen maintenance staff are the typical installers.

This lid is intended for use with Bunn-O-Matic coffee brewers that use an oval brew-thru reservoir configuration. These units are common in restaurants, hotels, convenience stores, and other commercial foodservice settings where high-volume drip brewing is standard. The brew-thru design keeps the reservoir covered during the brewing cycle, reducing heat loss and limiting contamination from the environment. This part is sold individually as a single-unit replacement.

Key Features

• Oval brew-thru design allows brewed coffee to pass directly through the lid into the vessel below
• Plastic construction provides lightweight, corrosion-resistant performance in daily-use environments
• Approximately 13.5 inches in length and 10.5 inches in width to fit standard Bunn-O-Matic oval reservoirs
• Inner diameter of approximately 2 inches at the brew-thru opening
• Depth of approximately 0.5 inches for a low-profile fit over the reservoir
• Sold as a single unit for targeted replacement without full assembly purchase

Compatibility

Designed as an OEM-style replacement lid for Bunn-O-Matic coffee brewing equipment using an oval brew-thru reservoir configuration.

Installation Notes

This part is installed by foodservice equipment technicians or qualified kitchen maintenance personnel. Before servicing, power down the coffee brewer and allow all components to cool completely to avoid burns from residual heat or hot water. No tools are required for lid replacement. Verify the reservoir dimensions on the unit before ordering to confirm fitment.