Allpoints 261750 Mesh Grease Filter 16x20x2 in Aluminum

Product Description

The ALLPOINTS 261750 is an aluminum mesh-type grease filter designed for commercial kitchen exhaust hood systems. Measuring 16 inches by 20 inches by 2 inches and weighing 2.9 pounds, it captures grease-laden air before it reaches the blower motor and ductwork. The mesh construction is engineered to trap up to 98 percent of foreign matter while maintaining efficient airflow through the hood plenum. Built from rust-proof aluminum, it handles the heat, grease, and repeated washdowns common in commercial kitchen environments. This filter is approved by the New York City Bureau of Standards and meets NFPA Standards 90A and 90B requirements. It is installed and serviced by commercial kitchen equipment technicians and hood cleaning contractors.

This filter is suited for commercial and institutional kitchen exhaust hood applications where grease accumulation is a fire and sanitation concern. Its design prevents grease drippings from falling onto cooking surfaces below the hood and protects the blower motor from grease buildup. The lightweight aluminum frame makes handling and reinstallation straightforward during routine hood cleaning cycles. It is recommended by insurance companies for grease control in commercial hood installations. Note that this filter meets NFPA 90A and 90B standards but does not meet NFPA 96 standards, which apply to commercial cooking ventilation systems.

Key Features

• Aluminum mesh construction traps up to 98 percent of grease and foreign matter
• Rust-proof aluminum frame withstands repeated commercial kitchen use and washdown cleaning
• Prevents grease drippings from reaching the cooking surface below the hood
• Protects blower system motor from grease contamination
• Approved by New York City Bureau of Standards; Appeal Cal No. 10-60 SM
• Meets NFPA Standards 90A and 90B; does not meet NFPA 96

Compatibility

Designed as a replacement mesh grease filter for commercial kitchen exhaust hoods requiring a 16-inch by 20-inch by 2-inch aluminum mesh filter.

Installation Notes

Installation and replacement are performed by commercial kitchen equipment technicians or hood cleaning contractors. The exhaust hood blower must be powered down before removing or installing the filter. Filters should be cleaned or replaced on a schedule consistent with local fire codes and NFPA guidelines applicable to the installation. Verify that the filter dimensions match the hood filter track before installation.